Danulearn Open Danulearn

Oromia model exam: Physics

⚛️ PhysicsNatural Science2017 E.C.Second semester · 1st round60 questions

📋 About this paper

Exam
Grade 12 Model Examination (Physics)
Subject
PHYSICS
Sitting
Second semester · 1st round · 2017 E.C. (March 2025 G.C.)
Time allowed
2 hours 30 minutes
Questions
60
Region
Oromia
Stream
Natural Science
Round
Second semester · 1st round
Exam directions
  • This booklet contains the Physics first round model exam for Grade 12. In this booklet, there are a total of 60 multiple choice questions.
  • There is only one best answer for each question. Choose the best answer from the given alternatives and write the letter of your choice on the answer sheet provided.
  • You are allowed to work on the exam questions for 150 minutes only. When time is called, you must immediately stop working on the questions, put down your pen/pencil and wait for further instructions.
  • Any form of cheating or an attempt to cheat in the exam will result in automatic dismissal from the exam hall and cancellation of your score.
  • Please make sure that you have written all the required information on the answer sheet before you start to work on the exam.

Part I: Multiple Choice

There is only one best answer for each question. Choose the best answer from the given alternatives and write the letter of your choice on the answer sheet provided.

  1. 1

    Two vectors A⃗ and B⃗ are given as shown in the figure below. Which one of the following vectors may represent A⃗ − B⃗?

    • AArrow A
    • BArrow B
    • CArrow C
    • DArrow D
    Show answer

    A Arrow A

    A⃗ − B⃗ = A⃗ + (−B⃗). A⃗ points up and to the right, while B⃗ points down and to the right, so −B⃗ points up and to the left. Their horizontal parts almost cancel and their upward parts add, giving a vector pointing nearly straight up — arrow A. Arrow D looks like A⃗ + B⃗ rotated, not A⃗ − B⃗.

  2. 2

    Two trains are traveling towards each other on parallel tracks. Train X is moving west at a speed of 80 km/h, and Train Y is moving east at a speed of 60 km/h. If you are on Train X, what is the velocity of Train Y relative to Train X?

    • A140 km/h towards the east
    • B60 km/h towards the west
    • C20 km/h towards the west
    • D140 km/h towards the west
    Show answer

    A 140 km/h towards the east

    Taking east as positive, v_Y = +60 km/h and v_X = −80 km/h, so v_YX = v_Y − v_X = 60 − (−80) = +140 km/h, i.e. 140 km/h towards the east. The speeds add because the trains move in opposite directions, and Y is seen moving in its own direction (east).

  3. 3

    Which of the following is a correct action-reaction force pair?

    • AThe force of a ball hitting a wall and the force of gravity pulling the ball down.
    • BThe force of a car’s tires pushing backward on the road and the road pushing the car forward.
    • CThe force of the bat hitting a ball and the force of air resistance on the ball.
    • DThe force of a swimmer’s arms pushing water backward and the force of gravity pulling them down.
    Show answer

    B The force of a car’s tires pushing backward on the road and the road pushing the car forward.

    An action-reaction pair is two forces of the same type that two bodies exert on each other, equal in size and opposite in direction. The tyres push the road backward and the road pushes the tyres (car) forward — exactly such a pair. The other options pair forces of different kinds acting between different bodies.

  4. 4

    A 0.25 kg ball is moving at 4 m/s and collides inelastically with a stationary ball of mass 0.75 kg. After the collision, they stick together. What is the kinetic energy lost during the collision?

    • A4 J
    • B2 J
    • C3.5 J
    • D1.5 J
    Show answer

    D 1.5 J

    Momentum is conserved: 0.25 × 4 = (0.25 + 0.75)v, so v = 1 m/s. KE before = ½ × 0.25 × 4² = 2 J and KE after = ½ × 1 × 1² = 0.5 J, so the energy lost is 2 − 0.5 = 1.5 J. 2 J is the initial kinetic energy, not the loss.

  5. 5

    A block weighing 200 N is placed on a frictionless inclined plane that rises to a height of 3 m over a distance of 12 m along the plane. What is the mechanical advantage (MA) of the inclined plane?

    • A1.67
    • B3.00
    • C4.00
    • D6.00
    Show answer

    C 4.00

    For a frictionless incline the mechanical advantage equals the ideal value, length of the slope divided by its height: MA = 12 m / 3 m = 4. The 200 N weight is not needed to find the ratio.

  6. 6

    What is the main characteristic of a third-order lever?

    • AThe fulcrum is at one end, with the effort on the other end.
    • BThe load is positioned between the effort and the fulcrum.
    • CIt has a mechanical advantage greater than one.
    • DThe effort is applied between the load and the fulcrum.
    Show answer

    D The effort is applied between the load and the fulcrum.

    In a third-class lever (e.g. tweezers, the forearm) the effort acts between the fulcrum and the load. Its mechanical advantage is less than one. Having the load between effort and fulcrum describes a second-class lever.

  7. 7

    Considering the relationship between atmospheric pressure and altitude, which evaluation best explains the challenges faced by climbers at high elevations?

    • AClimbers are less affected by low atmospheric pressure because they are physically fit.
    • BDecreased atmospheric pressure at high altitudes leads to reduced oxygen levels, which can impair physical performance and increase fatigue.
    • CClimbers do not need to acclimatize as atmospheric pressure has no significant impact on their performance.
    • DHigh atmospheric pressure at altitudes enhances climbers' endurance and reduces fatigue.
    Show answer

    B Decreased atmospheric pressure at high altitudes leads to reduced oxygen levels, which can impair physical performance and increase fatigue.

    Atmospheric pressure falls as altitude increases, so each breath holds less oxygen (lower partial pressure of O₂). This reduces the oxygen reaching the muscles, causing fatigue and poorer performance. Pressure at altitude is low, not high, so D is wrong.

  8. 8

    Which of the following is correct?

    • ATemperature is the measure of the average molecular kinetic energy of a gas
    • BInternal energy of the system is independent of its mass or the number of molecules in the system
    • CHeat is energy that can be transferred from one object to another at equal temperature
    • DTemperature is a measure of the amount of energy that flows from hot to colder region
    Show answer

    A Temperature is the measure of the average molecular kinetic energy of a gas

    According to kinetic theory, the absolute temperature of a gas is proportional to the average kinetic energy of its molecules. Internal energy depends on the number of molecules, heat flows only when there is a temperature difference, and the energy that flows is heat, not temperature.

  9. 9

    The sound intensity at a distance of 2 m from a point source is 1 W/m². What will be the intensity of sound at a distance of 4 m from the same source, assuming the sound spreads uniformly?

    • A0.25 W/m²
    • B0.5 W/m²
    • C1.0 W/m²
    • D2 W/m²
    Show answer

    A 0.25 W/m²

    For a point source the power spreads over a sphere of area 4πr², so I ∝ 1/r². Doubling the distance from 2 m to 4 m reduces the intensity by a factor of 4: I = 1 × (2/4)² = 0.25 W/m². 0.5 W/m² would wrongly assume I ∝ 1/r.

  10. 10

    Which situation best shows the application of both experiential and non-experiential knowledge in solving a complex problem?

    • AA scientist uses experimental data from a lab experiment and theoretical models to refine their hypothesis.
    • BA teacher applies established classroom management techniques without considering past experiences with students.
    • CA lawyer follows court precedents and applies personal experiences from similar cases to argue in court.
    • DA nurse consults a medical handbook, but only follows their instinct when making decisions.
    Show answer

    A A scientist uses experimental data from a lab experiment and theoretical models to refine their hypothesis.

    Experiential knowledge comes from observation and experiment, while non-experiential knowledge comes from reasoning and theory. The scientist combines experimental data (experiential) with theoretical models (non-experiential) to refine a hypothesis — the scientific way of solving problems. B and D deliberately use only one kind of knowledge.

🔒
Questions 11–60 are in the Danulearn app

Sit the whole paper with a timer, get your score, and read every answer explained.

Same exam, other subjects